88waggieguy
Well-Known Member
- Joined
- Sep 21, 2013
- Messages
- 134
Looking to reduce my trail rig inventory. I've got a 1988 Jeep Grandwagoneer the is pretty much a one of a kind. The body has been shrunk from a 4 door to a 2 door. The back half of the frame is now .25 wall 2X4. The interior and all exo cage is .120 wall HREW. Seats and harness are all tied to the cage. Front axle Dana 44 with 3.73, ARB, cromo axle shafts, super joints, and high steer with heims. Traditional sprung under suspension. Rear axle Dana 44 stock shafts, and one link using Balastic Fab uniball with track bar. AMC 360 engine was rebuilt about 8 years ago. All new rings, bearings, flowcooler water pump, three angle valve job, guide plates, roller tip rockers, hardened push rods, Comp Cam, Edelbrock intake, DUI distributor. Has header gasket leaks currently. Suprise!!!!!! TBI with Howell harness and writeable PROM chip. Tires are 35X13.50X15 cut Boggs on DIY beadlocks. Tires are in good trail shape and all hold air. AC compressor converted to on board air with 2.5 gallon tank. This is a great, good running trail rig. Has been on most of Windfock without pulling cable. Trail 15, Little Mule, Stair Steps, Trail 3, Trail 12 and 13. Get the just the rig will go. This was my first trail rig and I hate to see it go, but just have to cut back.
I am sure I am missing things.
Asking $2900.00 OBO, and no trades.
Best to contact me @ [email protected].
I am sure I am missing things.
Asking $2900.00 OBO, and no trades.
Best to contact me @ [email protected].