2014 Polaris Ranger lift install

Doing some work to my Ranger 900xp
Going to start with a lift and A arms and new wheels and tires
I will post some progress pics
Thanks to TACOMAJD for the research and input in another thread as to what lift kit and Aarms to use to clear 30" Rocktane's . So i didn't have to spend hours on the pc to figure it out on my own
We will see how it goes
Using
Superatv 1 1/2 " forward Aarms on front
Marshall Motard 2 1/2" lift kit
MSA M20 14" wheels & 30" Rocktane's


Sent from my iPhone using Tapatalk

Re: 2014 Polaris Ranger

Now pics


Sent from my iPhone using Tapatalk

Re: 2014 Polaris Ranger

Tires here



Sent from my iPhone using Tapatalk

Re: 2014 Polaris Ranger

A arms come in upper looked good
Pressed oh lower new ball joint in , fit great
Then Rh lower side went to put in ball joint and could push it in by hand
See video
https://vimeo.com/202587368
Called super atv and they are sending me a new arm .Sounded like it is a common problem with them . I wish they would have checked them before selling it .now I am at a standstill


Sent from my iPhone using Tapatalk

I got rear done




Sent from my iPhone using Tapatalk

Looks good! Hope your Roctanes hold air better than the ones I have owned and been around in the past.

Me too


Sent from my iPhone using Tapatalk

This thing looks like monster truck I mite have been better off with 28" for hunting club and hauling corn


Sent from my iPhone using Tapatalk

Yea Roctanes are big tires

Front lift not installed just put it on jack stands and slid tires on till get bushings and replacement A arm in



Sent from my iPhone using Tapatalk

Got front lift and Aarms on and tires and wheels I still have to tweak the alignment some towed in a little to much
Here's a few pics . It was time consuming had to remove brush guard to gain access to remove some arm bolts the Chinese grease fittings suck don't fit the gun well and Squirt grease everywhere going to swap them out for good ones



Sent from my iPhone using Tapatalk

Re:

Looks good!

Sent from my XT1635-01 using Tapatalk