• Help Support Hardline Crawlers :

TheViking builds a Bronco

TheViking

Targeted
Joined
Jan 24, 2014
Messages
1,881
Location
Chattanooga, Tn
Not much so far a 93 Bronco with a 351 Winsor and a new E40D, thanks to Patrick, nearly 300K on the clock. I bought it over a year ago as a project vehicle but life changed and I had to put it on the back burner.
 

Attachments

  • 14732235_182215988897554_464178357303325262_n.jpg
    14732235_182215988897554_464178357303325262_n.jpg
    109.4 KB · Views: 132
9495c8d35764e1b79cc3e42e65750f32.png


Mine is streched both ways rear four link on tons a doubler and full manual reverse c6 full hydro steering welded both ends and on a full body i have rearranged the fenders but the body is all there and its never been narrowed and its still tagged and insured. But with 5:13's and 37's i dont drive it near as much as i use to. But if it was overdrive id drive the holy hell out of it
 
Eric, you didnt happen to have some carnage at Windrock about a year ago did you? I gave a group of folks a ride back to their horse trailer(out of windrock)....they were wheeling a Bronco just like yours i believe. Ripped a knuckle off on the main trail, hit a concrete block protecting a gas pipe. Just curious.
 
I'm pretty sure he had an axle tube try to jump ship last year at windrock. I might be wrong tho.
 
Nope wasnt me. Sounds like some **** that would happen to me tho. But yea dont cut to much cast off a sd 60. The tube WILL pull out. Evan with a weld around it. Lol
 
I know I'm dragging along with the build just picked up a OSB F250 making changes and a few repairs to the commuter car. Going to get it tuned up in the next few weeks may not make the ride in Ky due to divorce and work :-\
 
Top