Re:
I also have a 2nd gen, 02 with a 6spd. I got the single disc valair, ceramic on one side Kevlar on the other. Works like a lot grabbier factory clutch. Holds to my 100hp sticks, cai, and quadzilla adrenaline. ..with. load on the trailer. :)
Installed 3 of these clutches probably 4 by...
Re:
Haven't used it yet...but I just bought a smitty x20-10, competition winch. Seems to be alot better built than the predecessor that I did have.
Sent from my SPH-L900 using Tapatalk
Re:
Good ol' dale Larson has been running 3/4" heims on all his links for 2+ years now...and has broken very few...just sayin'
Lots of people give him crap for it, but they're still in there, and still holding up.
;)
Re:
I have rock solids high steers of my UB 60...they are the shiznit! Double keyed and 4 hardened bolts. I'd recommend them over the dynatrac ones,, those (last I knew) were only single keyed.
Re:
Just checked, coreys bounty hunter is NOT a ball joint axle.
BuT Dale larsons is! That should be enough proof that they are tough eh..
sended frum dis stoopid fone
Re:
I know between 5-10, and I know there are more out there.
Call here and ask for Robert. 616 696 8114
He can tell u how many he has built for the "bouncers"
Not 100% sure on these. But some Michigan boys are running them.
I "think" Dale larsons Dana 80 is a ball joint outer?
I "think"...
Re:
I'm pretty sure if u get a Super Duty ball joint one, the tube are thicker wall as well.
I don't think you'd have an issue, I've seen some 14 bolt builds that use the ball joint outers.
I can say from experience, they are wayyyy easier to service. 6 simple bolts and the shaft can be...
Re:
Love mine! Seems to hold up just fyne.
As long as u get good unit bearings they seem to hold up fine too. BUT that's on a 3500# jeep. ;)
Aftermarket stuff is not as easy to find as kingpins...but rock solid performance sells high steer arms for em, they sell chromo parts all over for em...