Recent content by logon444

his setup is 5.3L lm7 4l60e atlas 5.0 and 4.56 axle ratio... so he is low

what the race team i run with stand point we have noticed on the axle shafts the caps walk out over a practice run and can start to hit the knuckle... and if your in a race and have to pull and replace a axle shaft you already have to pull the zerks to get them out of the knuckle so you dont...

i have a 11 gal cell in mine so i have the same thoughts... i bought this gas can thinking i could strap it with a ratchet strap on my cooler... and they stack so keeping them in the back of the truck is super easy!!!! https://www.tractorsupply.com/tsc/product/fuelworx-gas-can-5-gal-47905-c1

i have a buddy that works on turbo LS motors all day... he keeps trying to get me to put a small turbo on my buggy hahahaha i dont need that much nonsense to break stuff i break enough as it is i dont need any help!!!

i have been here for a little while but never posted up here... so here we go... very old werock buggy (built in 99-00 ish from what im told) won supercrawl in 2003 and got the fancy axles then... full tube chassis bilstine coil overs (for now thinking about putting ORIs or some other coil...

yep im interested in this... only problems i see from where i wheel (Texas and Oklahoma) is run time and charge time... we like to get up at 10ish and wheel till lunchish eat then back till dinnerish then wheel till we hope 12 or 1 which usually means 2-4 am... so i would be worried bout the...

haha yes sir you meet us at the ultra 4 races!! yep yep we raced the west coast and east coast series ultra 4 this year... it been too much fun but getting in the way of my wheeling... but its ok the season is almost over so wheeling will start up again!!!

i know this is a old post... for the people that welded it did you have to heat the knuckle and weld it like a factory cast knuckle or did you just burn it in??

Sent you a pm

I have heard good things about that gold tape... I was thinking about that lizard skin ceramic coating with bed liner on top so I don't wear threw the lizard skin... and if that didn't work I was gonna do a raised center console above the existing transfer tunnel with storage and all inside of...

Do you want pics of the buggy or the interior??

whats up guys.. i have a full tube chassis buggy (old we rock buggy) it has a 4.3L vortec 700r4 atlas.. aluminum floors (12 ga. if that helps anybody) my problem is it gets hot while wheeling for long periods of time... trans tunnel is hot to the touch and you cant rest your leg on it if...