Recent content by TwistedTiTan

You are right. I need to choose another cam and change that link

been thinking about this one . http://www.compcams.com/v002/Pages/396/XR276HR-10.aspx

Looking for some help deciding which cam to order . Heres what I have.... 93 SBC TBI short block ( standard pistons) 98 SBC Vortec heads 202 valves 60.4 cc chambers , springs good up to .500 lift Comp Cams 1.6 Magnum Roller Rockers Impco 425 single mixer compression should be about 9:1...

thumb.gif drool :cougar: drool flashemifyougotem :popcorn: ;D

Thanks for the advice fellows. :dblthumb: I have to swap the engine out sometime this week or next and while doing so I'll relocate the vaporizer into the engine bay area. Hopefully this will fix the problem. I'll post up the results after I move it and get it running again

I bought an old CJ7 with sbc on pane and the PO had the regulator mounted in the rear of the tub between the cylinders. Every time I go to start it, I have to reach behind me and hold the center button down with my right hand while I'm struggling to reach for the starter button with my left . Is...

Re: PSC Hydraulic Steering Kit Sold .. Thanks

Re: PSC Hydraulic Steering Kit Sale pending

Re: PSC Hydraulic Steering Kit ttt

Re: PSC Hydraulic Steering Kit top

Re: PSC Hydraulic Steering Kit http://www.polyperformance.com/shop/PSC-2.5-Double-End-Steering-Cylinder-Kit-p-17018.html

Re: PSC Hydraulic Steering Kit Yes its for a Dana 60. Its the 3.5 turn to turn and its 8" stroke.

Re: PSC Hydraulic Steering Kit Huntington, WV... Not looking for anything specific

I have a new in the box PSC Hydraulic steering kit that has never been used. I opened the boxes to make sure everything was there. The kit part number is SKU#: PSC-FHK110. Trail Series 2.5" Double End steering cylinder kit.This kit has never been installed. I have decided to go another direction...