Search results for query: *

Weld on cups to run 05+ Superduty Unit bearings on a rear axle. One of the Cheapest, quickest, easiest ways to go 40 spline rear. Bored for 3.5" tubes, but easily taken out to 4" (or even bigger) Located in Central Missouri (Mexico, MO 65265) $375 + Shipping

I'm looking for a couple of rockwell inners. Prefer long side. Right now just looking for mockup / test fit, so even twisted or broke splines are Ok if you're in the midwest & shipping won't kill the deal for everyone.

CTM's for a 60. Never installed, nothing wrong with them. Just considering going another route. $600 Located in Missouri 65265

Started this project & then decided to switch to a 609 front. Fab housing (built by myself) 3.5 x .250 DOM tubes, 3/8 faceplate, 1/4" everywhere else, +4" on short side & includes the brand new +4 TG 30 spline axle. Tubes are currently not welded, but will be before delivery (waiting in case...

Brand new, still in plastic, just changing directions. $65 shipped lower 48 North central, Mo

Aisin hubs $185 shipped North central, Mo

Set of 4, Lots of tread depth, but lots of rock rash. Bought new fall of 2011, offroad only. Stored indoors. Grooved & lightly siped when brand new. No patches, no plugs. Pics below show what I'd consider the worst of the rash. Also have a spare TSL, regrooved bald tire that...

Needing a good W56 input shaft.