Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
Goatbuilt JHF buggy build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="crazybluerider1" data-source="post: 1567495" data-attributes="member: 17477"><p>Lengths and locations have a lot to do with making it all fit where it can, no two rigs will be the same. The thing to do is to get the lowers up in the chassis where they fit and then tack in some uppers where you think you have room for them. Then run the numbers and see if they are in an exceptable ball park. I think it is more important to have a minimum amount of change through the suspension cycle rather than a specific AS number. These happen to be 50% rear and 60% front static. I also like to keep the roll center a little higher in the rear than the front, I think this helps make the rig more predictable in corners. A lot of this is pretty subjective and can very by driver though. If this is your first link job I would build some adjust-ability into the uppers at the frame at the very least and probably make sure I had room to move the brackets around, front to back, if needed. I had to screw around with my first one quite a bit to make it do what I wanted it to.</p><p></p><p>More confused now? :eeek::haha:</p></blockquote><p></p>
[QUOTE="crazybluerider1, post: 1567495, member: 17477"] Lengths and locations have a lot to do with making it all fit where it can, no two rigs will be the same. The thing to do is to get the lowers up in the chassis where they fit and then tack in some uppers where you think you have room for them. Then run the numbers and see if they are in an exceptable ball park. I think it is more important to have a minimum amount of change through the suspension cycle rather than a specific AS number. These happen to be 50% rear and 60% front static. I also like to keep the roll center a little higher in the rear than the front, I think this helps make the rig more predictable in corners. A lot of this is pretty subjective and can very by driver though. If this is your first link job I would build some adjust-ability into the uppers at the frame at the very least and probably make sure I had room to move the brackets around, front to back, if needed. I had to screw around with my first one quite a bit to make it do what I wanted it to. More confused now? :eeek::haha: [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
P
Official "Post your trail riding pics" Thread
Latest: paradisepwoffrd
Today at 9:49 AM
General Discussion
Golden Mountain Off-road Park opening
Latest: 1tonrenegade
Today at 9:38 AM
General Discussion
Coalmont TN OHV New Park info
Latest: jeeptj99
Today at 8:55 AM
General Discussion
Hollar wood offroad park next weekend
Latest: baldduck74
Yesterday at 4:22 PM
General Discussion
Cash LeCroy Illness
Latest: ridered3
Yesterday at 1:02 PM
General Discussion
Forums
Rock Crawling Forums
Tech & Fab
Goatbuilt JHF buggy build
Top