Rogue fabrication bender

[Jonboy]

looking for some feed back if any one has used one

 

[Neal3000]

I think InDaShop knows a lot about tube bending, you might want to pm him!

 

[hokie_yj]

I think InDaShop knows a lot about tube bending, you might want to pm him!

I have one. It's done great for everything I've needed. It bent 1.5" .250 wall like it was nothing. I also have their notcher and drill press reduction kit. I've been happy with all of them.

 

[canepari]

I've owned a Pro Tools 105, Mid American EZB1000 and a Rouge for the last few years. I hated the Pro Tools 105 it was slow and the ratchet part is just stupid. The Mid American is fast and simple to use but is only good for .095 and thinner and 90 degree or less bends, It was great when I was building dirt track cars but the bottom fell of that side business. I really like the Rogue, It's fast and ez to use. The 4.5'' radius dies let's you keep everything tight. I guess my only complaint is the pressure die setup, It works fine but i wish it had a follower block setup like the Mid American. It's a great bender for the money, ez to assemble, operate and I don't think any hobbiest will be disappointed with a Rogue.