Search results for query: *

2021 Iron Bull Trailer, twin 7 k axles with brakes on both. Trailer was 83" wide but I added the extra width where the buggy sits. We would typically put our 2 dr RZR on the front and our buggy on the rear. We pulled it behind our motorhome with has an incredibly long ass so I did a spring over...

I have a GM Hydroboost and master from an 05' 2500 gas truck. I have a Kingpin 60 front with factory calipers and a 14 bolt rear with the Lugnut dana 44 brake kit. I installed a Wilwood prop valve for the rear. On a dirt road in 2wd i adjust prop valve to keep rear from locking up first. I'm a...

I have a king pin Chevy 60 front with stock knuckles and high steer arms. I have the ARP studs and their tapered nuts holding them on. Obviously in future I'll move to stronger knuckles and associated arms but in the mean time, what do you think is stronger? Tapered nuts or conical washers with...

New build, I used the Goatbuilt subframe. 3 upperlink bolt holes front and rear at frame side. Buggy is to the point of riding around neighborhood, testing all systems. I'm getting the traditional torque over to the right under hard acceleration in 2wd. Been trying to google set ups and not...

So first half of team leaves out Jan 28th. Get there early for shock tuning, engine final tune, general test running. 3 trucks towing out, race car in enclosed, goose with buggy and 2 RZR for pre running, and bbq gril and kitchen on 3rd trailer. We gonna set up our camping compound outside of...

Recently purchased a Class A gas motorhome, gonna toy buggy and toys. So I'm in the market for a bumper pull car hauler and have some limitations. Motorhome only has so much balls, need to keep what I tow light. I will address the rear frame strength, pretty good to start but I will add a...

Wife and I have had a couple of enclosed race car trailers to tow with and to camp in. We did some basic finish out on the inside and they worked out pretty good. We never had a proper shower or toilet, just had the little camp toilet and it worked out for emergency's. Our goal is to carry a...

So, I have my rig for the most part figured out. The chassis is sitting on a table, engine, trans, t-case mounted, radiator will sit in place. The suspension is all in place. I just have 2 tires on the rig and suspension full flex so that I can allow for tire clearance and room for shocks during...

I'm to the point in my build that I'm ready to make a choice. I have King pin GM 60 front with new OEM disk and calipers, 14 bolt rear with Lugnut 3/4t disk conversion and the smaller JB6? calipers. I have Stock LM7 5.3, 4L60E, Atlas 5.0, 4.56's and 43 SX This buggy is a recreational trail...