My 2013 JKUR had a run in with the edge of a concrete driveway resulting in a destroyed front rim, bent lower control arms, and who knows what else at this point. I ordered and installed a set of Barnes4x4 lower control arm mounts and put it back together then took it to the alignment shop HOPING they could get it aligned because the camber looked off just looking at it. They said they got it back in specs but it's obvious the camber is still off. Jeep has the C gussets already on it. With all the brackets on it how do I figure out where the bend is if it's bent. I'm assuming the long side axle tube is considering the gussets on the C's are there. Any ideas or "been there done that" ideas??