pbmcauliffe
Well-Known Member
Vision X LED bar, avaiable in 6", 8", 12", 22", 32", 42" lengths, 2.75x3"
2-16 amps draw depending on size, 8-80 3watt LED's depending on size, and $279-$1675 depending on length
The one shown is a 22" version
-
Help Support Hardline Crawlers :
KOH Tacoma
- Thread starter pbmcauliffe
- Start date
2-16 amps draw depending on size, 8-80 3watt LED's depending on size, and $279-$1675 depending on length
The one shown is a 22" version
Not Jobless
Mr Funbags
Does it give an output power comparable to standard lights? Like 55W, 100W, etc...?
pbmcauliffe
Well-Known Member
The spec sheet didn't so I called them and this is what I got:
The Lumen output is greatly effected by the quality of bulb and reflector used, but on the higher end of lights (Lightforce) figure that a 100 watt light will be about 15-20 lumens, lower end lights can be far less.
The 22" led bar is rated at 7200 lumens at 8 amps draw, so 7200 lumens/15 = 480 watts of output, or 360 depending on what you divide it by.
The Lumen output is greatly effected by the quality of bulb and reflector used, but on the higher end of lights (Lightforce) figure that a 100 watt light will be about 15-20 lumens, lower end lights can be far less.
The 22" led bar is rated at 7200 lumens at 8 amps draw, so 7200 lumens/15 = 480 watts of output, or 360 depending on what you divide it by.
Dovetail96
Well-Known Member
That means you don't want to be in front of my truck! That thing looks bad Pat! Can't wait to get out there. Inner axles are ready, stubs shipped we are gettin it for sure.
I was telling you that.. That thing is bright. I would be affraid a UFO was chasing me.
I mean its Hella freaking bright. I want one :booo:
Dovetail96
Well-Known Member
Should get er done at about 80mph in the dark. My training for Baja and my new trophy truck ride that will follow my KOH finish!
Dovetail96
Well-Known Member
pbmcauliffe
Well-Known Member
Got the floors, firewall, most of the trans tunnell done, pedal monts done, winch mount done and some of the brakelines all done.
Bodaciouscj7
Well-Known Member
Got the floors, firewall, most of the trans tunnell done, pedal monts done, winch mount done and some of the brakelines all done.
Looking good, hope I can get my hands on it to build the exhaust.
Not Jobless
Mr Funbags
Judging by the welds it's steel and currently not removable.
pbmcauliffe
Well-Known Member
yes steel, outer sections are fixed, center section are removeable.
token-negro
Member
Not Jobless
Mr Funbags
pbmcauliffe
Well-Known Member
:haha: :haha: :haha:
pbmcauliffe
Well-Known Member
Tore it all down last night and started painting the chassis, ran out of paint, just got more so finish the painting this morning. Start re-assembly this afternoon and start plumbing, finish wiring. Waiting for the torque converter, mass airflow, axle shafts and drivelines.
Pics or it aint true.:redneck:
