toyodaaddict
Well-Known Member
Iv got an old 22re with a rear main leak. I pulled the seal and the crank is grooved where the seal rides. Ive seen this alot on pinion/tcase flanges and sometimes sanding the groove out works.
Anyway I was thinking about sanding the metal edge of the new seal or doubling up the seal housing gasket, in an attempt to get the seal to ride in a new spot:redneck:. Anyone tried this?
Anyway I was thinking about sanding the metal edge of the new seal or doubling up the seal housing gasket, in an attempt to get the seal to ride in a new spot:redneck:. Anyone tried this?