Not your toy 85
Well-Known Member
have a 360 bored/ stroked to 410 ci. Engine was built by pierce race engines in Lansing Michigan. 4.040 bore,4.000 stroke, 6.125 rods, dished pistons, dual spring(comp) comp cam.holley truck avenger carb.edelbrock air gap. I have a build sheet and dyno sheet
I purchased a cj7 off nc4x4 with this setup. It sat for a while. After cleaning fuel Lines, draining tank, and putting a tune up on it I got it running. Sounds great. Really not a mopar or carburetor type of guy.
Trans was gone through and has new converter and reverse manual vb.
I know quite a few things about this engine/trans combo. And what I don't know I can get from p/o. If you have any questions please feel free to call or text. It is still in jeep so you can here it run.
It's located in winder ga. 30680 Im asking $3000 and will also throw in the painless harness in the jeep. Thanks for looking.
678-936-6996
I purchased a cj7 off nc4x4 with this setup. It sat for a while. After cleaning fuel Lines, draining tank, and putting a tune up on it I got it running. Sounds great. Really not a mopar or carburetor type of guy.
Trans was gone through and has new converter and reverse manual vb.
I know quite a few things about this engine/trans combo. And what I don't know I can get from p/o. If you have any questions please feel free to call or text. It is still in jeep so you can here it run.
It's located in winder ga. 30680 Im asking $3000 and will also throw in the painless harness in the jeep. Thanks for looking.
678-936-6996
