Sold/Expired Custom BlueTorch V8 One Ton Jeep Buggy Crawler

[fountain]

I bought this Jeep as a one ton leaf spring YJ and wheeled for several years then sent it to BlueTorch Fab for a full custom build. Jeep was built by Dan Dubose and Rob Parks. I had kids during the build and never got back into riding so its in like new condition. It is for sale or trade but would prefer to trade for a JKU. I will also trade up for very built JKUs. I need a back seat for my kids that are now old enough to ride.
Jeep has a clear title and I have it tagged and insured to drive on the road.

94 Jeep Wangler YJ
Fuel Injected V8
Flat top pistons with a cam and 10:1 compression and around 400HP
700R4 Automatic Transmission
Motor and Tranny only have a few hundred miles on them if that
Art Carr Shifter
Atlas 4.3 Transfer Case (new)
High Pinion Front D60 Axle with 35 spline axles and Detroit Locker with 5.13 gears (gears new)
D60 Rear Axle with 35 spline axles and ARB Locker 5.13 gears (gears and locker new)
4 wheel disk brakes
Custom 1410 Drive Shafts (new)
Fox Coil Overs Front and Rear (new)
Custom 4 linked suspension front and rear
PSC Full Hydro Steering (new)
New 42" Irok tires (new)
Walker Evans Beadlocks
Aluminum Racing Radiator with electric fan (new)
Fuel Cell (new)
Optima Yellow Top Battery (new)
AC compressor plumbed to Air Tank to run ARB and air tools or inflate tires (new)
X-Large PRP seats and Simpson Belts (new)
I am 6'5 so I built the cage tall and used large seats to accommodate big people.
Front Warn 9.0 Rock Crawler Winch (new)
Rear Warn ATV Winch for sucking down the suspension (new)
Removable Steering Wheel (new)
Spray Floor Liner
Moab Heater (new)
12volt Guy in dash winch controls and ignition, ARB, headlight switches (new)
New gauges
Aluminum Roof
Half Doors
Lexan Windshield

Located in Perry, GA
$27,500
478-955-zero8two3

 

[fountain]

pics

 

[fountain]

pics

 

[fountain]

pics

 

[ranger11]

Dang you local And I've never seen that rig. Why not spend a little money to add seats to that? Be better than swapping to a jk.

Sent from my XT1635-01 using Tapatalk

 

[fountain]

That's probably my next move. Just need recommendations on a reliable shop. Ive been out of it for awhile so not sure who to use. I've talked with Wide Open Designs about it.

 

[muddinmetal]

Use Dan again. This is the new shop: https://www.motobilt.com

 

[Blase]

I too vote to just have Dan tube the back to add a rear seat. Is what's left of the tube full width? Would love to see some more pictures of it. Specifically the back half inside and out!

 

[fountain]

BTT