Dana 60 Ford High pinion 4.10 gears and open, Artec full hydro truss, high steer arms, 8 arp studs and nut kits also two knuckle bolt kits.
truss is tacked to the axle and was tacked to my frame for mockup. Other than that it has been marinating in my garage. The axle was wire wheeled and stock backets removed and coated with rustoleum primer in most areas but where I was going to weld. Axle has stock shafts, one joint is junk. I have 35 spline chromo's and hubs available but will sell them later when I dig them out.
price for all is 1800
located in the Atlanta area.
truss is tacked to the axle and was tacked to my frame for mockup. Other than that it has been marinating in my garage. The axle was wire wheeled and stock backets removed and coated with rustoleum primer in most areas but where I was going to weld. Axle has stock shafts, one joint is junk. I have 35 spline chromo's and hubs available but will sell them later when I dig them out.
price for all is 1800
located in the Atlanta area.