mdo817
Well-Known Member
- Joined
- Jan 17, 2011
- Messages
- 1,905
What will cause fluid to aerate to the point of being foamy. Set up is either 7.3 or 9.7 ci Eaton orbital, 8x2 double ended surplus ram, PSC reservoir mounted above a PSC performance jeep pump, with a grill mounted tranny cooler, line comes out of the top of cooler back to reservoir. System has worked good for several years, but I wound up getting a kink in the line going from reservoir to pump, straightened that out, did a 3 day run at wind rock end of last year and pump started whining pretty bad towards the end of each day, found fluids aerated. Jeep has only been ran a couple times since, and that was New Years, same thing, started off quiet, longer it ran, worst it whined, Jeep been setting since, only cranked about once a week, and moved a few times, today starting to prep for April Harlan ride, pump is quiet, but fluid is very foamy. Any ideas why? Should I just flush fluids and start over?
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk