NP 205 parts questions

[DeleriousII]

The front output shaft of my GM 205 is 30 spline. Right now it has a flange on it. I would like to put a 1350 yoke in the flanges place. I have done a great deal of searching and cannot find anything. Do you guys know if this part exists? If so, where can I get one?

 

[DeleriousII]

i might have been off by one spline...it is 29 i think.

 

[jeep46]

Heavy Duty didn't work? Try driveline specialties, S turn in Harahan.

 

[jeep46]

Try to match the spline and u-joint. You can change the seal on the case tomatch the thickness around the splines.

 

[DeleriousII]

heavy duty sucks...not only did they not have the front one but they want almost $90 for the rear

 

[Juan_Hong_Loe]

You tried Jess at highangle?

 

[blacksheep10]

highangle. its right every time I order a yoke from there.

 

[3 tons o fun]

I might get that 30 spline front output shaft and fange from you.

 

[blacksheep10]

so you are wanting to just swap yokes? or are you going to the 32 spline.
anyway, call jess, about $75/$80 for one with ubolts thats new.

 

[Marty]

I am running a 32 spline flange from my 208 on my 205, they are in the juckyard everywhere, Mine is only 1310, but I think a 1350 flange is the same but not 100%

 

[blacksheep10]

yes, if you want a flange and have the 32 spline output on the front. if you're 30 still and want a yoke, buying aftermarket is about your best bet

 

[Marty]

Ah, yep hes right, I read it like you wanted a flange my bad.

 

[DeleriousII]

I wanted to just put a yoke instead of a flange....the reason for all of this is I want to run 1350 u-joints all the way around....and be able to carry 1 as a spare.

Thanks for the input!!

 

[3 tons o fun]

You can get 1350 cv's from Jesse too.