kushKrawlin
Well-Known Member
That's fawkin it! I need an answer to this.. About to start links on the samurai , I have about 20 hours looking and reading and biting finger nails.. I still cannot ****ing figure Out why the hell anyone would run the upper link on the front over the chunk? In other words the link will be close to the drive shaft.. Total opposite of my 3 link set up.. But chunk is on the same side as mine. I've noticed that about 90% of the people run the link on the passenger side For some reason.. Anyone tell me why!?? It's driving me mad. :****: why not run it like mine is set up , where the panhard and upper link axle mounts are on the driver side?? Opposite of the drive shaft!?? Gonna post a pic to make sure we are on the same page!
I may be over thinkin this and it may not matter.. I just have to know why the hell anyone would go to that side with the upper link ... I'll be goin full hydro if that has anything to do with this... Thanks for any advise. I'm frusterated. Bad. No finger nails left to bite off. :****:
I may be over thinkin this and it may not matter.. I just have to know why the hell anyone would go to that side with the upper link ... I'll be goin full hydro if that has anything to do with this... Thanks for any advise. I'm frusterated. Bad. No finger nails left to bite off. :****: