Does anyone recognize this valve body?
This was installed by someone else and I don't know who. The transmission was also rebuild then. I am having trouble with reverse. The trans feels like it it is bound up once under a load. It works just fine on flat ground but as soon as you give it a little throttle it binds.
My problem is once I removed it I found a check ball and don't know where it goes. I found the installation directions for a tci 221100 reverse manual valve body. Those directions say I should have two check balls and a spring. Also the purple separator plate does not have a hole in the location where to says to put one of the check balls. Has any one seen this valve and piont me in a direction as to who made it?
Sent from my XT1585 using Tapatalk
This was installed by someone else and I don't know who. The transmission was also rebuild then. I am having trouble with reverse. The trans feels like it it is bound up once under a load. It works just fine on flat ground but as soon as you give it a little throttle it binds.
My problem is once I removed it I found a check ball and don't know where it goes. I found the installation directions for a tci 221100 reverse manual valve body. Those directions say I should have two check balls and a spring. Also the purple separator plate does not have a hole in the location where to says to put one of the check balls. Has any one seen this valve and piont me in a direction as to who made it?
Sent from my XT1585 using Tapatalk