I apologize if this is a 
thing to do but I can not get pics to load up there so I am pasting a link to pirate. If this a against the rules or just in poor taste let me know and I will delete it but would like to get some input today if possible so I can start on the rear tomorrow. Specs are:
Putting a set of Yukon 4.88s in my dads 90 pickup. It looks ok to me but think the pinion could probably come in some.
Truck is a 3.0, 5spd and will run 265/75/16s open front and elocker rear. Backlash is .006-.007 and I dont remember the pinion shim spec (can get it if needed) but it is the stock shim. Forgot to add I put in a solid spacer in place of the crush sleeve if that matters. And the truck is a DD/farm truck so nothing hard core about it.
Any input is appreciated. And I can get more pics if it helps, but mainly concentrated on coast since its an LP front diff.
Here is the link to pics on pirate, TIA
http://www.pirate4x4.com/forum/toyota-truck-4runner/2041082-7-5-ifs-front-gear-pattern-check.html
thing to do but I can not get pics to load up there so I am pasting a link to pirate. If this a against the rules or just in poor taste let me know and I will delete it but would like to get some input today if possible so I can start on the rear tomorrow. Specs are:Putting a set of Yukon 4.88s in my dads 90 pickup. It looks ok to me but think the pinion could probably come in some.
Truck is a 3.0, 5spd and will run 265/75/16s open front and elocker rear. Backlash is .006-.007 and I dont remember the pinion shim spec (can get it if needed) but it is the stock shim. Forgot to add I put in a solid spacer in place of the crush sleeve if that matters. And the truck is a DD/farm truck so nothing hard core about it.
Any input is appreciated. And I can get more pics if it helps, but mainly concentrated on coast since its an LP front diff.
Here is the link to pics on pirate, TIA
http://www.pirate4x4.com/forum/toyota-truck-4runner/2041082-7-5-ifs-front-gear-pattern-check.html
