wizzo said:I'd check with:
Wide Open Design
Sunfire Offroad
Essentially Offroad
kmcminn said:Wide Open just carries stock valving as of 2 or 3 weeks ago.
No sure about the other two.
Poly Performance carries them but you will pay 15 in shipping.
Chris at Alltech is the most resonable. Unfortunately he is on the left coast.
wizzo said:Not sure if the OP is looking for pre set valving or just valving to work with. If you just need more valving, I'd think whatever WOD has would get you the additional valving you want. Just ask. Or if you want pre done, I'd suggest contacting Chris@ Alltech or Accutune. Both are on the forum but not the east coast.
Just as a wild guess judging by your spring rates you are close to me in weight. Try this as it should get you in the ballpark and if it's stiff on the slow stuff use a flutter.Adam90xj said:I went from a 50/80 to a 30/50 on all 4 corners. As it was jarringly rough. Now the front is too soft, blows through travel and dives under braking. The rear is pretty close but still a bit rough through small bumps. I think a flutter stack there would work better.
Fronts 100 over 150 spring
rear 100 over 125 spring
Aluminum 5.3
Th350
atlas
1.75 DOM
All alum panels
It's fairly "lite" for what it is. I currently have about 1.5" of preload on the springs. I am only running 5.5" ish up in the front and 6.5ish up in the rear.... I plan to rework the front (chassis&COtabs) to allow for a bit more up travel.
I didn't have time yesterday as I left work early and put a deposit down on a used enclosed goose neck!
I'll call around today and see what I can find for help/suggestions and what's in stock.
Thanks guys,
Adam