Search results for query: *

So, getting ready to purchase a case & struggling what to go with. I have a built 6.0 around 500hp built for low end, th400, 60/14 with 5.38s on sticky 42's (eventually 43's). There's a good deal on 3:1 case, just worried I would want deeper like a 3.8. I'm not bouncing & certainly not...

Atlas TH400 Adaptor kit. Use with 1.5" output shaft. Retail is $240 asking $175 obo Lincoln, NE

Have to liquidate current build to fund some property. All parts are in Lincoln, NE but I have a Fastenal store just down the street for shipping. Shawn @ 4026101476 I'm on phone a lot, so leave message, post up here or shoot me text/PM. Come pick it all up & I'll make you a deal! Baja XRS...

GM D60 Kingpin Front Axle DRW 4.10 gears Stock 14B with no carrier or r&p. D60 has been disassembled & mounts ground off. It's complete except has no brake calipers. Great shape. Bearing caps have been marked. Removed everything to get measurements for custom front axle I'm building. I have...

Looking to save as much room as possible for driver side 2-piece front shaft....would it be possible to run two passenger side shorty headers & flip one around for the driver side? I'm planning on dumping driver exhaust around front of oil pan.

Looking for stock setup to the motor (w/hose). Anyone have one lying around you'd be willing to ship? Shawn

...and not your typical vehicle thread. Click on the link. Enjoy. thumb.gif http://www.bcsportbikes.com/forum/showthread.php/146566-Build-to-Fail-Fail-to-Build.-What-is-this-I-don-t-even.....

I'm getting ready to position my coilover mount locations and just need some advice.... Shock has 38" ext / 23.5" col length. I'm shooting for 5" of up travel. Does that mean mount coil @ 33" position or do you control that height by other means? I'll be running air bumps, as well. Again...

I'm guessing this has been discussed ad nauseam, but ran a search and couldn't find much. Guessing you guys are harder on components than anyone. In your opinions, are machined hubs OK to run? I can buy a used pair of srw for $250 or new for $500. Better just to buy???

I've been working on this since February, so I'll just post up some pics from the start. As I mentioned in the newbie thread, I'm a big fan of Coleworx and wanted to mimic the Riddler build, so I hope that's taken as a show of respect and not a ripoff. thumb.gif I was going to go with a TJ...