jmh78
Well-Known Member
What are you using and what are your attachment methods to keep from fighting distorted bolt heads?
For those of you running AR plate did you happen to bend any of it during fabrication or weld it?
I was wanting to run 1/4" AR400 but I wanted to bend tabs up along the outside edge that I could bolt throgh to keep bolt out of harms way.
For those of you running AR plate did you happen to bend any of it during fabrication or weld it?
I was wanting to run 1/4" AR400 but I wanted to bend tabs up along the outside edge that I could bolt throgh to keep bolt out of harms way.