I've been too busy to work on my buggy in the past year and all it has been doing is collecting dust. I've decided I'm going to let it go to a new home.
It is a project and will need a little bit to complete.
The chassis was built buy a guy out of Melborne FL, it is all .120 and .188 D.O.M, Four link has 1 ¼ Heims and are made out of 2" .250 D.O.M, For coilovers it has 16" Big Shocks 2.25 Coilovers. It has two Corbeau baja SS seats and a 36" Corbeau bench seat mounted also.
It has a 5.3 LS motor, Th400, And NP205. The 5.3 was a junk yard take out and ran when pulled but has been sitting. The person I purchased the transmission and transfer case from stated that they were recently rebuilt at the time I purchased them. It has a B&M torque converter also.
For axles it has Rockwell 2.5 ton axles which come with BTF Mohawk kits that have not yet been installed. The only steering parts that I have for it is the orbital and a mount for the orbital. It will need all of the fuel system and wiring to complete. Most of the hard work is done, I will also include a sheet of .125 aluminum that I was going to use for the floor pans.
I'm not looking to trade at this time. Price is $8000.00 Firm It is Located in SWFL
If I don't sell it or am talked out of selling It, I will just keep it and finish it when the time is right.
Feel free to message me and I will get back with you.
It is a project and will need a little bit to complete.
The chassis was built buy a guy out of Melborne FL, it is all .120 and .188 D.O.M, Four link has 1 ¼ Heims and are made out of 2" .250 D.O.M, For coilovers it has 16" Big Shocks 2.25 Coilovers. It has two Corbeau baja SS seats and a 36" Corbeau bench seat mounted also.
It has a 5.3 LS motor, Th400, And NP205. The 5.3 was a junk yard take out and ran when pulled but has been sitting. The person I purchased the transmission and transfer case from stated that they were recently rebuilt at the time I purchased them. It has a B&M torque converter also.
For axles it has Rockwell 2.5 ton axles which come with BTF Mohawk kits that have not yet been installed. The only steering parts that I have for it is the orbital and a mount for the orbital. It will need all of the fuel system and wiring to complete. Most of the hard work is done, I will also include a sheet of .125 aluminum that I was going to use for the floor pans.
I'm not looking to trade at this time. Price is $8000.00 Firm It is Located in SWFL
If I don't sell it or am talked out of selling It, I will just keep it and finish it when the time is right.
Feel free to message me and I will get back with you.