Recent content by 340SHORTY

Presision Driveline in Totem Lake built my rear shaft when I went to a D60 in my RC. They also used to fix the 1s I broke in the Peterbuilt dump truck I used to drive..

Around the Safeway parking lot.. other wise dodging the potholes on the Middle Fork or Tinkam Rds...

When I was in high school(many moons ago) I bought a semi auto Savage from Coast to Coast hardware. I shot the crap out of it. When the extractor disapeared the second time I bought a new Marlin Model 60. The Marlin was a piece of junk. i took the Marlin back the next day and bought a Ruger...

ruffstuffspecialties has them. IIRC they are around 50.00 a pair..

Tinkum Rd exit is 42. The road crosses the river then basicly parralles I 90 and comes out at the Denny Creek exit # 47. There are a couple of roads that cut off to the right leading to higher elevations. There are no off road areas or very many turnarounds, just the roads. If you fubar its a...

Did it run after the rebuild??

You didnt know if the block was factory or not but you say you dont like blocks. What is you basis for this idea?

Is that on the road that Ys off to Cadman ??

the guys that make brake lines, The Right Stuff has adapters that use a screw in rubber brake hose. IIRC they are 10.00 each..

Try Dan @ NW Differentials in Totem Lake/Kirkland. last I knew he was 225 per + parts for a setup. Quality work and fast turn around.

NO BRAZING thats to hot.. use SOLDER !!!

where did the NAPA go that was in Carnation just south of the QFC??

buddy has a 01 Quad Cab Dually absolutely loves it.

10lbs, pffft.. thats bait. Im a Salmon Slayer

probally 1 of those trailers that doesnt have a full frame..