Recent content by Craig

More pics.

Sold. Thanks, Craig

Re: HARDLINE CRAWLERS MEMBERS ONLY TEES That was a mistake. Check again I just ordered one.

Re: Re: Electric hydraulic pump for steering? I have electric power steering now. I thought about going that was and putting a steering box on it but I am wanting to push the front axle out a pretty good bit.

Toyota axles, 5.13’s and 36” TSL’s.

that's a thought. I'll have to do some looking and see if it will turn the pump fast enough.

Say you were doing something kind of odd and putting a set of Toyota axles under a SXS... I am trying to figure out the steering. I would like to go full hydo but I don't have any way to turn a power steering pump. Do any of you know of an electric hydraulic pump that might work? Some kind of...

delete?

Call Coosa Steel. They may deliver up there. Not sure about for one sheet though. Also I was wrong I am paying .49c a pound delivered.

that's pretty close to spot on what I am paying. I don't buy a ton of volume so I was just wondering.

What are you guys paying for 1/8", 3/16 and 1/4" plate in 5x10 sheets? I'm in North GA just curious what others are paying. When using on a plasma table are you using hot rolled plate or P&O? I bought P&O once because the "sales man" said the cut quality was sooo much better and less slag but I...

I put the GO EFI 400hp kit on my 300hp SBC and I am loving it so far. My only complaint is I am on my 3rd set of plugs. It needs to be driven on the street to really learn I think. Mine is on a crawler so it never really gets over 3500-4K rpms. FiTech said this is most likely my issue and it has...

I would also like a couple XL.

AUD has to be one of the best reads on the internet. that and the Union Creek Journal.