Recent content by Free89BroncoII

Thats what I was hoping to hear. Thanks Crazy

Need a little help here. Just picked up a 64' Chevy that I am going to build into a Truggy. Currently it has the Eaton HO52 rear axle, 4.57's with the "no slip" (Detroit). This is an axle that I have zero knowledge about but from what I have read is a pretty decent axle to use. Now, the truck...

:kissmybutt:

well, none the less..... I appreciate your help

uh.. ok.... I was looking for advice on what specs and how to figure out what was needed... not that I can buy it from surplus center. I found a good write up on Pirate.... thanks for you help though :kissmyass:

I appreciate your help... :flipoff: , I did do a search and I see alot of where to buy, but that wasnt what I asked. No biggie... I'll look elsewhere

Im looking to run full hydro on my 89 Bronco II. I know companies like PSC sell full kits and they also sell parts. I have seen alot of people buying orbitals on Ebay... going this route, what do I need to look for in a valve? Any help on this would be greatly appreciated

Thanks guys....

Im looking for anyone local to weld a set of 4 KORE beadlocks to a set of rims. Im located in Bremerton but dont mind traveling some for quality work....

Price on 15X8's....5 on 4.5