Recent content by gasman1

Nice Job..... Spent last weekend fishing for Tuna out of Illwaco on Sat. and Westport for Salmon, Ling cod and Rock fish on Sun. We ended up with 8 tuna for 8 guys. The seas were so rough on Sat. it made for some very difficult fishing. The wind was blowing with gust of 25mph with 6-8ft...

Manshtash can be accessed by Barber Spring, Tamamrack Springs, Mud Flats, and another area by Tamamrack springs but i cant remember the name of the road :mad: But accessing the camp ground is another story.

Got a call from the guy I was supose to go with today to teh Puyallup and he kept 4 and caught 10 :mad: While I ended up helping my wife pack for her camping trip this weekend :mad: Thats ok, I am going to Illwaco and going for tuna on sat. and then to Westport for salmon on Sun. :cheer:

Your situation sounds simular to mine. I added 2" longer shackels and it moved the angel from the front end to transfercase enough to cause the wobble. When I replaced the lift shackles with the originals, the wobble whent away. In order to stay with the lift shackels I need to sim it, so just...

Just my $.02, but masking a problem don't solve the problem. What is causing the wobble? Sprung over or under? Did adding the leaf's, add to the length away from the transfercase or the angel of the DL?

Did it wobble after the lift shackels were put on, before, or the whole time?

Angle of the front end maybe (pumpkin). I put lift shackels on the front of my YJ and would have the wobble at 45mph to 58mph after that it was fine. Took out the lift shackles and went back to stock, and never had a problem after that.

It's a BBQ/Pig Roaster :awesomework: There is a thread on here some place about it. Here it is http://www.nw-wheelers.com/forum/showthread.php?t=52993&highlight=roast

I have not weighed it yet, but it's around 65lb.

You can buy one for $500-$600, and that is what I would charge to make one. material cost is about $250-$300, depends on where you get the stuff at and a few hundred labor to build, you are better off building your own or buying one new. Here is the web site where I bout the plans from. They...

Well, idecited to build my own Duck HUnting Boat. I wanted a boat that I could throw in the back of the truck and take to about any small pond, lake marsh, etc, I wanted to. Here are some pic of my build process. The material cut out. Assembling the bottom half of the boat. Fiber glassing...

No. I made a gamble to hang the anilam from my trailer receiver. We would skin them and debone with out gutting. Worked great and we had it down to 18 minutes a goat. Kinda get good after a total of 10 in two days.

3 Deer in 1 ice chest :haha: I had 5 antelope in 1 ice chest last year from WY. :kissmyass:

What did you get? I was draw for Obserbatory Archery Bull Tag :fawkdancesmiley: :fawkdancesmiley: :fawkdancesmiley:

There is two bike trails that I know of up there. One is near Lost lake and it is not worth the time, it is to short to be any fun, and the other is across the Hwy up Wildcat Creek area. Ity is 8 miles long and runs the border of the wilderness area. It is the Russell Ridge trail #1111. I have...