Recent content by highgearonly

Mine was built for more technical rock crawling, which is what I prefer. I run fiberglass hood/grill/cowl, and you’d be surprised at how well they hold up. Alum skins which are replaceable, and fairly cheap, and really do keep the mud/debris out. Chassis and suspension really are best of both...

Sold

PM sent

Top, OBO

Sale pending

Bump OBO

Pretty much have everything except gears 14 bolt axle 35 spline Mark Williams spool Mark Williams full float shafts Motobuilt shave cover Artec upper truss and pinion tie in Artec backbone Also have Solid 14 bolt hubs with 5 X 5.5” pattern. Have standard 1/2”-20 press in stud holes, but I...

Had a couple people ask Axle has 35 spline chromoly axle shafts and is 5 X 5.5”

Sold

Sale pending

Tera HP 60 CRD rear axle for sale. This uses Dana 60 HP gears, but bottom of axle is rotated to improve clearance. Been a great axle, had behind 4.3 V6 and 5.3 V8 with no issues. Axle is 62” WMS-WMS, but comes with 2” spacers on each side for 66” WMS-WMS. So can be either width. 5 X 5.5” lug...

I have 4 used Radflo coil overs for sale. 2 - 14” travel with 12” 150 lb/14” 200 lb springs 2 - 16” travel with 14” 95 lb/16” 150 lb springs Both have triple rate tender springs. Were used for 2 seasons of wheeling. Typical wear on all bodies and spanners. Have all spacers, and can...