Recent content by jjt4806

all sold

Now that I've gotten into dumping $$ and time into my full size rig, its time to get rid of a bunch of my RC items. Unfortunately, none of it is crawler related. However, I've probably got one of the biggest collections of 1:10 - 1:8 scale off road rigs around. WAAAAAY too much to list...

I think a clarification should be made - the OP is looking for a steel cut-off saw I assume. You can use a standard chop saw to cut aluminum all day long. A better blade would improve it, but it still functions fine. I'd be concerned (keep my on) the aluminum hinges etc on any chop saw used...

Which one was that? Low 9's is about the best being achieved so far. Lenny at DDP has a new truck this year. Looks like a nice set up - expecting to see some good runs outta him once it gets "broke" in. Littel Red Rocket is my fav for local trucks. Rottin Rhonda runs a helluva fast 4x4 (into...

No, I said SHOULN'T ruin one....based on stock power levels. Now, if your not stock, you are your own warranty provider..... When I blew mine, I was only at 10K on the clicker. But I was running Beta Test software (which malfunctioned), and I knew I wasn't going to be happy worrying about the...

I had a very nice tranny built for my '06 by a shop down in Kent (Mark something....they are in the old Chev Dealership building). Cost me about 4400 - had everything but billet shafts done. It was quite a pill to swallow with only 15K on the truck, but I knew that if I was going to play, I...

Did you recently do an oil change? Sometimes the Common rails do this right after an oil change. May want to do some research on one of the Cummins Forums