Recent content by JPTHING

SAS:awesomework:

So here is another one for ya, 11479 inch pounds = 956.583e Ft pounds correct???

You are correct! Awesome, I couldn't figure out how it was soo many rpms to go 30mph. Thanks

Help me with my math I want to figure out how many times the drive shaft needs to turn to go 30 miles an hour? here are the specs: 47" tire = (12.25' Circumference) 5.13 axle ratio 30(mph)x5,280(feet in a mile)=158,400 (feet per hour) 158,400/ 12.25'(tire circumference)= 12,930.61 tire...

Do we have to be trained in some special way??? Cause Nicole and I would like to come and help!

Hell with his grammar, I would have bet he himself owned a Toyota. :fawkdancesmiley::fawkdancesmiley:

I just wanna know what happens over the next 4 years, So I can get prepared.

Myself and my buddy are willing to help just need to know at least a week in advance. PM me

My Douchebag friend asked me to post this question. He has replaced the starter, ignition switch, starter relays, neutral switch, and checked the fuses, and his XJ won't start. He is hoping for some other suggestions. And yes the battery is charged, and connected.

You should do 1/4 eliptic, or coils, and avoid the bending problems.

I agree, cause I have a worn out 4cyl, ax-5, np231 YJ, and broke 44 Chromo shafts left and right, I had to buy a second, cause I was breaking them before I got off the trail. Of course I have 10,000lb boggers, but that can't be the problem!

How bout Aermet 100 Shafts, and gears, they won't break

60's are :rb:, I know a gay guy(Money Mark) who broke 300m 60 shafts, with cheesey krawlers, I would go bigger if your are goin 42" tires, 60's break too easily...

Do this instead, I have lived in Utah for the past year, and Jeep prices are way less down there. Here is just one example of what to expect. If you buy something, I would bring it into town in 1 month, when I go to pick some of my stuff up, I would charge a cheap fuel fee. Just a thought...

this is for a 1/4 eliptic setup, so we only care about something that is near 36" from centering pin to loop. More length will mean more droop. JSYK I don't care to hear BS problems with too much droop.