Recent content by LiftedZuki

****, i needed 30 spline fj80 longs soon. Pretty sure I'm SOL!! I doubt trail gear will do them special request. I'll be 4k into an axle nad only be able to do 24 spline at the birf!!

Tacoma! Had a 99 2wd and now a 98 4x4 3.4 5 speed Only mid size truck I'd own. Hold resale better than almost any other truck. Sold my 2wd reg cab 99 for 3500 last December.

http://diy4x.com/cart/index.php?route=product/product&product_id=100 Could even do something like this. I can use the factory mount holes but figured 6 floor plates with 4 grade 8 bolts would be better than 6 factorys with holes in the tub for the tube work.

no ideas? Thanks

I'm building a new 2x4x.188 frame for the LJ buggy build, I'm at the point that I don't know if stock body mounts should be used.. Considering running 5x5 plate and 4x4 plate on top. Would be about 6 of these (2 by the feet, 2 behind and 2 at the back) I'd think this would be plenty tough to...

16v, toy axles, snatch/cradle from ZOR, t case gears from trail tough

Got a line on an lj81 I'm really wanting, missing engine n stuff, hopefully getting it and use all these takeoffs

Too deep I think. Turn thr ring gear with a wrench and hold flange witj a rag it'll get you clearer pattern

Thanks, I didn't feel like fabbing at all, allergies has me beat down, 0 energy. So I drank an energy drink and made myself get the upper link done LOL.

The pan hard mount will tie the SE ram mount/upper axle side mount into each other. 4.5" frame sep 9" axle sep 36.5" center to center lowers 35" upper 89% AS

36 iroks btw. Bald. Just to get it rolling.

Yeah, gotta look into them for the tacoma.. And remote start lol

Lower link mounts than I'd like but I did a calculator and got my stuff set how I wanted and this is where it puts me. I'm planning on moving to AK so not too worried about it right now. Might end up having to run a 2x2 box skid frame anyways when I put dual yotas in it, and will make it close...

Very cool