Recent content by r47

Finish my nurse practitioner coursework so I can work less with my back than I do as an RN, which is less than I did as a medic... Teach my boys to shoot and drive and maintain both Pay off the house (and maybe sell and move from MI to UT)

For what it's worth I put one of these 1350 flanges on mine: http://www.wfoconcepts.com/pr/Flange-1350-1310-CV-32-Spline-Multi-Bolt-2-Inch-Pilot/3328 I *did* have to shorten it on the lathe (and have no idea what I went to at this point 2 years on). Think I used a national 473204 on it too...

For what it's worth, PAC springs were cheaper for me to order through summit than direct as long as orange was ok. They also have shipping delays listed on some, but they typically beat the estimated eta. The stupid part is they actually drop ship from the next county over but of course if I buy...

Have one too, haven't used it much *yet* but seems repeatable and good to go.

Hate those trampoline joints, local one opened up last year and seemed like we had an ortho patient every other day for a few months from there. Sorry about your hockey/baseball/football/track season kid, here are your crutches. Can be surprising what a 3mm stone can do to a full grown man too..

Just bought a set of rotors last night for a bit under half normal, listed as new with damaged original packaging...

Ok, I'll take a look when I can. I saw the measurement on pirate and sidelined it.

Have one in the garage pile, I'll try and have a look tonight.

Bingo.

Anything wrong with advance auto's agm group 34? With an online code it's around $135..

Bought a Lotos LTP5000D for $299 on a sale through newegg of all places. Works, wish I had it a year earlier and I need to open the case to check for the famous loose terminals. Pilot arc sputters and might just be a loose lead somewhere.

Bernie for the primary to block H, redistribute Bernie's vote in the actual game to someone who needs it.

I bought the 2015 version Alphatig 200 and it's been solid so far for figuring out wth I'm doing. The new 2016 version has high freq pulse on DC fwiw...

On 241's, is there any point to getting away from the longer bell flange to run a SD 1350 CV shaft? I don't have a shaft yet, but was planning to swap in a short front output and get a 32 spline 1350 CV flange from High Angle to make it all work. The only thing I don't have is the 1350 flange...