Recent content by Retribution

Truly SAD! My wife and I met her a few years ago at SEMA and we were both saddened when we received the news.

Wished this was broadcast every Sunday

Got mine today, thanks John. Happy the wife & I could help the charity! If I may ask what font type is used in the Hardline Crawlers?

What do you use for tubing and what is the diameter? Also, how do you connect tubing? Weld, braze, solder?

Re: Re: Need Dimensions & Angle, PLEASE! Yea, I probably am over thinking it but, I want to minimize mistakes by thinking it through first. One bit of information I obtained from your post is "8" top to bottom frame rail will accommodate most t'cases & give you a mostly flat floor". This is...

Guys I've got a couple more questions, please. Can someone tell me the separation between the upper and lower rails and is it different front to rear? Also, do you use .120 or .188 wall tubing for the main rails? Thanks

I too have the same question, anyone?

PM Sent, 2nd Order, Wife wanted in on the action.

John Really like the art, can't wait and happy to know the money is going to a good cause!

Thanks Guys, I really can't believe one die is used for the entire chassis. I thought there would be various bends requiring different radius dies.

Elliott - Thanks for the info, I got a PM from another Hardline member and both of you gave me roughly the same dimensions, thanks again. Now that I got that info, I have to ask what radius bender die do I need to fabricate a full chassis or do I need more than one? If one or more than one, can...