Recent content by rufnek79

I recently rebuild my entire front dana 60 axle and was wondering if anyone runs a bellow on the axle tube vent or do you run a hose up and out of harms reach away from water and debris. Would like to hear the pros and cons if anyone has experience with these...will they hold to much pressure in...

Thanks for all the input guys that helped alot ....that makes my decision easier

I figured this would the best place to find a review on this cover. For the price they seem to be the cheapest but sometimes more than not you get what u pay for...any one have any thoughts on these covers. Looking at a Dana 60 ..Thanks for any comments good or bad.

I worked at a hydraulic cylinder manufactor for a few years and the best grinder we had was a bosch... I think it cost around $100 but it out lasted everything we had twice over. I now own one with no regrets.

nice cut away pic. that should help alot of people out if they have never seen one before. :dblthumb:

more pics of side view plz looks like it could possible work as long as the material is thick enough to hold the threads. good job.... i may have to try.. that let us know how it works out

Re: need help with keeping a drive shaft I had a problem similiar on my jeep, my rearend was drooping down alot when i would give it the ol southern bump and binding, then making mine break . I went with 1410 joints and the bigger body lets them have more drive angle but that was just my...

mine are precision gear havent had any problems

anybody know a decent place to buy that type of carb to filter housing just curious ..sorry to get off subject

Same here i modified my rails and made my own shifters out of some flat stock and tierod end from a lawn mower ;D.. laugh if you want but it works great ill try and post pics ....just be extra carefull when or if you decide to grind your rails, do it slow and check it often or you'll be able...

x2 northern drivetrain .. i bought 1410 for my 205 and 14 bolt they have a wider body and allow for more driveshaft angle without binding my 02

Signed

found some paper work had address Southern Fluidpower 4816 Bonny Oaks drive chattanooga tn

bought mine from a place off bonny oaks in chattanooga ...been a while cant remember the name of the place he was very help though... make sure you mark each piece exactly how they line up ...took mine apart thinking it didnt matter and had a mess ...dont know if this helps any

i put one on my pickup been on for 7 years no problems what so ever... its just the extra brake light and signal .... got it from stylin concepts .. i got some cheap light from northern tool and put under rear bumper on toggle switch for extra back up lighting