Recent content by s.frimodt

I would think any sort of stock Motorcycle muffler would be great in this case? They flow pretty good compared to how quiet they are, and if you can't find one you feel is big enough just fit two instead

I like that DIY quick release! Is that just a PTO coupling for a Tractor? And if you want the clocking on the wheel to always be the same (If you don't run full Hydro) I suppose you could simply cut off one spline on the male end and weld the gap between the two on the female end?

Even though I never in a million years would be as good a Fabricator as you, this is still a huge inspiration, and there's definitely a lot to be learned from your skills, out of curiosity, how many miles of weld do you think there is on this thing so far? Must be more than one would imagine

I can tell you guys, even over-here in the cold Scandinavia we are getting hot from these pictures! Especially that intake made my head all fuzzy! Great job for sure!

Here's how I did mine 4 years ago, runs like a peach at all the angles it can stand on without falling over. Even with the fuelgauge showing way low. Basic and made out of various pieces of scrap. But works really well. Suction Tube is of course in the middle of it all.