Recent content by vogelj

I have had a lot of problems with bleeding my rear mounted radiator as well. after talking with Wide Open Design they gave me some good tips that made it way easier. - Drill two small 1/8" holes in the thermostat. - Fill the engine full of coolant through the top fitting on the water pump. -...

Something else to keep in mind is the way you bleed a dual master cylinder set up. You need to bleed front and rear at the same time or you will be fighting the other master cylinder.

Build is looking sweet! Do you have any concern about the fans being so close to the fuel cell?

I emailed about everyone listed above except Mast. I got the runaround from most of them. I ended up calling Tilden Motorsports and they built me a new harness and flashed my PCM. It was definitely more expensive than having one cut down but the quality is amazing. Every thing is clean...

I was wondering when this thread was going to pop up. You definitely have a good start. Can't wait to see what you come up with on the rest. You might finish two before I every get mine done!

Re: LS 5.3 TUBE BUGGY How big of a person can fit in this buggy?