-
SXOR single seater build
I got the steering straightened out this morning. I just had it a little off when I put the tie rods in. Toe is set at 0" +/- 1/16" and you can slide a piece of cereal box between the stops on both sides with the ram at full lock either direction. After I got that straightened out I started...- hokie_yj
- Post #525
- Forum: Tech & Fab
-
IMG_0114.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0115.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0116.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
SXOR single seater build
I had a little more time today and bolted up the unit bearings to check the fitment with the Spidertrax rotors, Wilwood calipers, and JHF/Branik caliper brackets. Everything fit just like it should. I also used shop air to cycle the steering lock to lock. Maybe because of the offset ram...- hokie_yj
- Post #524
- Forum: Tech & Fab
-
IMG_0085.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0086.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0087.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0098.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0099.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0100.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0101.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
-
SXOR single seater build
Just had a few minutes this afternoon before work. I stuck the new 7075 tie rods on the axle to make sure they fit. And I also replaced the temporary upper link tabs with the permanent tabs. They will be gusseted and tied into the back side of the ram mount.- hokie_yj
- Post #521
- Forum: Tech & Fab
-
IMG_0079.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0075.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0077.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
IMG_0078.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
-
SXOR single seater build
I actually got in a little bit of shop time today for the first time in ages. I decided to stick with the Goatbuilt ram mount and run the ram offset to the driver's side. I had to get a little creative to get it mocked up in place to tack weld only having one set of hands. But it's on there...- hokie_yj
- Post #519
- Forum: Tech & Fab
-
IMG_0033.jpeg
- hokie_yj
- Media item
- Comments: 0
- Category: Offroading Gallery
