Search results for query: *

  1. H

    new project

    Got this fella in trade for a Jeep I had. The body is straight and it runs good, its got some electrical gremlins going on and needs a new driveshaft but overall in decent shape. Aside from the electrical my first project is going to be bumpers.
  2. H

    Jeep YJ 4x4 issue

    Recently got done lifting my jeep, tried taking it through the storm drain in front of my house to flex it out only to discover my 4 wheel drive doesnt engage. I have a 231 tcase with a posi lock to engage the axle. I pull the handle out(about an inch of travel) and the 4x4 light comes on but...
  3. H

    body lift and suspension lift

    Finally got my lift all done. Havent had a chance to drive it a whole lot but for the short drive I took it is 100 times better than it was before. Saving my pennies for wheels and tires. flexes well for a brand new lift.
  4. H

    body lift and suspension lift

    the mounts under the doors look to be straight. the jeep is on the ground right now.
  5. H

    body lift and suspension lift

    So I got my body mount bushings in the mail finally went out and put them on followed the directions that came with them but they look off. It says to put the lift spacer on top of the body mount bushings is this right?(spacer, metal insert, rubber bushing frame) (PIC BELOW) Also my rear...
  6. H

    body lift and suspension lift

    I have a 92 YJ 5 speed that I just recently got. Im in the process of lifting it starting off with a 1 1/4 body lift which will be finished once the new body mount bushings get in. I am also installing a 4 inch Rough Country lift that comes with the t case drop. My question is how is that t-case...
  7. H

    Body lift nightmare

    ordered new bushings wanted to veryify im doing this right as the directions dont mention using any of the old bushings. each mount should be the tub, lift puck, rubber bushing, frame mount, rubber bushing, washer and bolt is that correct?
  8. H

    Body lift nightmare

    Got my body lift in the mail yesterday for my YJ got excited and went out and started to install it. I had already sprayed everything down with pb a couple of times so I thought it'd go relatively easy. Right off the bat broke off the two rear bolts on the rear cross member damn, continued...
  9. H

    POS jeep wont start

    There's a shrader valve on the fuel rail that you can hook a gauge to test the fuel line pressure
  10. H

    welder repair

    It turns on but when you pull the trigger its like the motor is bogging down.
  11. H

    welder repair

    Found a lincoln 100 welder at the pawn shop the other day. Tested it in the store and discovered it wasnt working properly. It wont feed the wire. Had it listed for 200 offered him 100 Figured id take a chance on it and hopefully find an easy fix for it if not Im not out that much. Anyway...

Latest posts

Back
Top