Search results for query: *

So what do you think the worth is on some turbo stuff? 22ret complete with harness and computer R series tranny with T-case Turbo/V6 rear end

The new Can Opener

I am soon to start a new project and have been going over what type of motor to throw in me yota thing. I am looking at the pros and cons of what you people have out there. So I figure my options are: 2rz/3rz-----have heard of oiling problems at extreme angles, expensive, hard to...

What would you expect for $400? I found a 85 efi straight axle that is in a state of disrepair. The motor is all tore apart. The bottom end is still merried to the tranny and bolted down but the head is off. The front window and rear slider have been taken out. The top center section of the...

I took over 90 of these bad boys.......

As it says above. It is setup for a SAS conversion. Anyone have one and how much did you pay for it?

Me and a few of the down south boys hit up TSF

I may have a chance to buy a 80 longbox Yota. 20r motor, 4 speed, close to new 33" Cooper snow tires, lift springs new head gasket, and brakes. Last time I seen the rig it ran poor and I am told that the battery is dead now. Hasnt been out in probibly two years. The rear box is beat bad and if...

I am starting to get a groove in the shakle from the leaf rubbing on it. The same is happening on the other side. Is this no big deal? Jonny joints? 4 link? (ha,ha,ha, not now......not yet anyway)

Hydro assist for a Toyota. The rig is a street legal rig, with duals, suspention, 35s, ext... From what I gather so far a 1.5" ram can work with a stock pump but is a bit sluggish. I am not looking for slugish steering. I assume that a 1.5" am with a upgraded pump, rez, and cooler will not be...