Search results for query: *

Does anyone in Oregon or Washington re center hummv wheels.

I bought this gear set used; they said they were for a CJ Jeep. After trying to set up gear to get a good pattern, I am not so sure. It is an AMC 20 in a 76 CJ narrow track. I need help Identifying the gear manufacturer so I can run the numbers.

ttt,

The Bearing journal closest to the flangeand mesure around 1 15/16 inch to the top of the gear mounting surface. from the top of gear mounting surface to the top of the bearing journal is around 4 11/16 inch.

Yea! the gears did get here to day!:awesomework: thanks

Not sure, but I think it was 4.11. I thought that the gears would fit on a 3 or 4 series carrier? doesn't it have to do some thing with the thickness of the carrier?

I have a Dana 30 carrier. How do I tell if it

I had the same thing happen to me. I put in a DUI dist. and it kick ass I have had the thing covered in mud/water it didn't miss once. plus it use a chev dist cap.:awesomework:

If ya are trying to figure out what the problem is, I would jack up the front end and spin the tires. If the both turn then most like it's not a axle shaft if just one spins it mite be a axle shaft or carrier or ring and pinion. Remove the diff cover and look for broken teeth or part in the...

Winch Mount Here is pic of what I did. I have a V8 in my jeep and when I put the winch on Man, did I notice a lot of weight in front. I think that the farther back over the axle the better. I have no over heating problems I just used some 1/4 inch plate. It works great!

Well it might be new some of you. A friend told me about this, I had never heard of this but it worked. If you don't have a bearing race pull just put two one inch or so welds on it one on the top and on the bottom. Just make sure you don't weld the race to what ever you are pulling it out of...

Thanks pokey I didn't know they make spools for a AMC 20 just hope its not an arm and leg.:clappy:

Oops some times my finger have a mind or there own. I don't think that they make a spool for AMC 20 do they?

weld a trac loc? Has any one ever welded a trac loc? did it last? Did it have any other problems?