Search results for query: *

Thanks for the help, I'll probably give you a call sometime next week to set something up. They did pull a code from the port under the steering wheel, but it was an intermittent speed sensor code/radio interference (I wasn't clear if it was the same code with 2 possible meanings or 2 seperate...

As far as I know, no they have not. The only diagnostic equipment I am aware that they used was a code reader and a pressure gauge hooked up to the trans while driving. Are those inidividual sensor readers common to most specialty trans shops? It feels to me like the shift points are correct...

Finally pulled the pan last night, replace the fluid and filter. Buddy with more experience than I said there were alot of shavings on the magnet, but he'd definitely seen worse for 200+k miles. How difficult are those electronic parts? Can I do those by just pulling the pan or do I have to...

The OD light did flash the first couple times it happened, but has since only flashed once or twice in the last few months.

It looks like it's getting to the end for my DD, but I'm hoping someone on here has heard of a similar issue and knows the likely cause. First off, it's a 98 F150 with the 5.4 V8 and auto trans w/ OD. Lifted 9" on 37's and 3.73s (Don't know if that's stock or not). It's got 220k and as far as...

Yup, I didn't understand a word of that. I don't know S about carbs. How much would it be to have someone do all that on a rebuild relative to getting a new one? Also forgot to ask, if I get a new one, how big should I go? 650cfm? FI is in the long term plans, but there's plenty more to...

I've got a 79 wagoneer 360 in the cj and need some carb input. The head sheered off on the bolt that keeps the throttle plate(?) tight on the top of the motorcraft 4bb carb. Now if I get over 40 mph-ish it chokes itself out and dies. I've found this isn't good on I-5. This gives me all the...

got it. thanks again for meetin up with us :awesomework:

ummm yes. I usually don't make it south of tacoma more than about twice a year, but I just happen to be working in Kelso on Wednesday. Meet Wednesday afternoon sometime?

hmm, i may be interested in that. how does that 44 match up to the model 20 as far as width, spring mounts, etc? In other words, how much work is it to mount up the d20/44 setup under my cj? If I went with the d20 case, does that match up with the offset on the front d30 I've already got? I...

I've got a 79 cj7 w/ a 360, TH400, and quadratrac (w/o 4-low). I've so far had no luck finding just the reduction unit at any local yards or online as a new or refurbished replacement part. The closest I've found so far is a full case w/ the reduction unit attached at oly4x4. Anyone on here...