Search results for query: *

Master on/off switch in cab plus controls next to it. Always have my factory controller along for the ride sometimes getting out and seeing what's going on is important!! The controllers on dash or factory are control switches for solenoids mounted on winch very minimal amps used = no heat for...

There's a 20,000 YouTube video!!

I currently have the b&w hitch in my ford, same problem as before release lever rusted not to sure locked or unlocked. Round style hitch now with a tab to keep ball from going all the way threw all in all has always towed everything I needed to tow for the last 7 years from gooseneck camper to...

What I figure I'm going to end up with, is a superior spool, Yukon eliminator kit, Yukon gear setup kit, 4.88 Yukon gears but i already have the gears and a crane dif cover. I have 2 drum 8.8s and a disk 8.8 but thinking I'll go disk for the yj since the width is the same so I don't think i need...

From what I have seen Yukon does both patterns as well hadn't seen anything about production locations. Sounds like both make one hell of a kit and not much difference.

Ready to get rid of my C clips! Have spent some time reading but people seem not to give any reasons why they like or do not like them. One way or the other looking for real world input. Any help would be appreciated. --- I am here: http://maps.google.com/maps?ll=47.153433,-119.336107

Wished I didn't but I fit in with quite a few of the posts on this topic. I got a snorkel on my TJ from back in the day for the water crossings that I shouldn't of did but did and it saved the motor everytime. Got a poo pipe exo on my 4runner it even has a couple feet of square tubing on it but...

Mostly emission were the death of 2 strokes but I'm a 2 stroke guy and it's funny to have every four stroke guy compare themselves to a two stroke wow you beat 35 year old technology but I do say its all where you race length of track your just comparing hp to torque and torque only can get ya...

I would try to mount it in front of the wheel-well on the drivers side that way it's not in the bikes way blind spot and not screwing around taking it down but that's just me

As for now it's 9 to 3 Dana 60 you and everybody at my shop all agree Dana 60 time I'm putting and ad out so if you guys see anything let me know thanks again for the help

Factory 1ton but still dana 44 with 8 bolt kills me no 60 under in already....:mad:

Got a 72 blazer ls motor 400 trans 205 case with Dana 44 front turning 38 tsls 13.5 wide mostly mud but some trail tired of loosing the front axle/ujoints everytime I put it in four Looking at Ctm joints 470+shafts Nitro 300m 310+shafts Yukon superjoints 340+shafts Yukon axle kit 980 with super...

10th has a letter to yours is L for 90 till 2001 then started with numbers

So far I think it's USA origin Jeep made for jeep Mpv multiple purpose Gross weight 4001-5000 Cherokee model Laredo package 4 door wagon 4.0 l engine 1990 production year Assembled in Toledo Ohio plant one Sequential serial was 99530 Let me know if I'm on the right track when I get more...

New to your forum been wheeling for a long while 30 married with 2 kids and a baby on the way july 5th. I have a full size 72 blazer mud toy that has 10" spring 40" swampers and ls 388 with a th400 and 205 also ready to crawl with my 97 tj 3 link front and 4 link rear on radflo coilovers and km2...