Search results for query: *

I like a trail that forces you to do the obstacle in some form. Probably one of my favorite trails i've ran was Holy Cross. Once you're in there you're pretty commited. It isn't that hard of a trail for a decently built rig, but once you're past the turn out, you either do it or turn...

Did you sell this?

Whats up with the old square body sitting behind it?

I got your txt but once we got to the camp ground my phone went to crap. They ended up finding a parts store to order one and got it back going Saturday. Thanks for the help though. Been a minute since I have been that long without cell reception. It was quite nice.

Buddy just busted one on the trail and called looking. Anyone have one? TJ Rubicon. Short side. Need both shafts and a joint. PM or TXT 864-871-0four four four

Milledgeville, GA

This was Black Bear on 9/4/20. It was brutal up there. Had a great time in Ouray and will definitely go back.

Our plan is to hit Holy Cross up on our way to Moab in September. Would love to hear your story about it. I haven't seen what trailer parking is available near it.

I recently went with a BTR Stage 2 Truck series for my CJ. Hope to have it on the street/trail in a few weeks and will let you know my opinion. It's as big as you can go w/o changing a converter. The numbers look really good on it as it gains TQ/HP all through the curve. Be really careful...

I have a porter cable. On my second one. First one lasted 6-7 years. It's the only one I could find with a trigger that felt comfortable. I ran a wire wheel on it for 6 hours a couple weekends ago and she's still going. I'd replace this one with another...

Sit them on the vice and use a punch to drive out the bolt collar, then the rubber should pry out with some work via pry bar. You will likely have to use a second punch to drive the first punch out of the collar.

More durable, easier to clean, and if you paint it with anything decent you’re going to have a whole day in prep and painting. Plus painting a chassis is very difficult to get coverage everywhere so you end up with thin spots that rust over time in my experience. I had around $150 in supplies to...

Found some.

Front. SRW.

Looking for two Dana 60 wheel hub assembly's. 864-871-0 FOUR FOUR FOUR

Were currently planning a trip for early September. Whats the story on Area BFE?

Cage pending sale for next weekend. Sliders sold. Corners available.

Have a Gen-Right CJ/YJ cage kit fully assembled. I am going a different route with the build. SOLD Poison Spider Steel Sliders SOLD Poison Spider Aluminum "Comp-Cut" crusher corners $300 OBO All as pictured on the CJ below. Located Greenwood, SC. Call/TXT 864-871-ZERO FOUR FOUR FOUR

My biggest truck driver pet peeve is they ALWAYS seem to show up at lunch time. Then they call and get pissy because my guys aren't there...