Search results for query: *

Before i tear my 203 range box apart AGAIN. Anyone got any suggestions on pluging the holes this dumbass forgot to weld closed. I know what needs to happen really open to ideas though. In my defense though its been 5 years since I had apart.

Sounds perfect, thanks. I get on the struggle bus alot these days.

Im cheap, and was trying to figure out another route by having a tab in this section

Thats my biggest worry

Thanks guys, Ive put a couple lines together to try and measure the gap. And get different measurements each time just hand tightening.

Those who have made their own tabs, what gauge steel did you use? Looking to make a tab to go between female flex hose an male hard line. I have the buggy kit from WOD. Be hardlined most of the way.

Damn it is an election year isnt it :ROFLMAO1:

No ****, been waiting on a reply from offroad design since last week :drinkers:

Rain baby rain

Went to Blue hollar in KY, Sat for a day trip buddy wanted to let his 15 year old drive his Jeep around, another buddy had his first trip out in his sxs, son took his 4runner, i was in a sxs. Sad how bad that place has got, trash everywhere in the parking lot, beer cans/ plastic bottles all...

Never been there, now i wanna go there

First time we went, buddy rolled his stock 4.0 YJ, broke both engine mounts, and trans mount. Had to drive into Virginia to find replacement. Same trip another buddies TJ pickup coil died at lower rock garden. Had to drive into Virginia for a replacement

I have the vulcan protig 205, it's better than I am. I bought it 2 years ago, and hadn't done any tig for 30 years. I also like the ability to stick weld with it also.

I found some finally, in my searching not once didn't summit come up in my search. I'm sure the issue was with me:****:

-8jic x m18x1.5 inlet -8jic x m16 x 1.5 outlet

Update on experience with this, thought we would have to swap out factory regulator, decided not to. Purchased a new Toyota regulator and installed it just to see, so far TJ pump doesn't seem to over powering stock regulator. It honestly runs better than it did before, plug check good, no gas...

I've searched and can't find sizes for hydroboost I might have wording wrong, I use to have it wrote down, but that said paper is lost. It's off a 85 cucv and the ports have already been gutted, wanting something with male -8 JIC

It will do that, is engine high mileage? Or built with a rowdy cam

Asking because I've had them hiss before, at the push rod, done vacuum checks with propane, carb cleaner, brake clean. With no vacuum leaks.

Have they all had vacumn leaks at the push rod? If you lived closer I'd give you a used one to try