Search results for query: *

Need a new gear box, but looking at going to hydro- assist Psc has there kits but they want a lot money for there gear boxes and I am not sure if it's worth that money for there gear box Also looking at getting a redhead gear box and having them do the extra ports if they will do that and then...

Olympic 4x4 in snohomish,they Even carry some in stock

I just bought a set of corbeaus and was told I could bring them back for the wider seats.the normal ones are tight.

Wish I would have know this years ago.i have been just using full synthenic 75/90

Just read somewhere that spec has change on what type of fluid to use.chrysler says to use 10w30 motor oil. When did this happen.well guess I will give it a try,at this point it can't make anything worse with over 200,000 miles on it

I have ten factory 30 spline rear shafts and have had one shaft replaced with just twisted splines,no question asked. I have never yet busted a rear shaft. 35 tires,arb locker. Have twisted a couple drivers side rears

I learned that lesson along time ago with my 96 dodge short bed,melted the side positive post

4wheelparts in lynnwood

I just bought two red top group 25 battery's for my jeep because I now run dual battery's. Will see how they do over time.

Match book

Pipe fill is based on 40 percent fill,any more than that and it gets harder to pull with the more bends you have

Who's playin the banjo

Yes it was air in system, but got crap in the thermostat so it stuck open so I just changed it

Air in the system would make sence.i filled the radiator and the I did something that I normal don't do.I put the radiator cap on and started it. I normal leave the cap off for a couple minutes after I start the engine.

Replace my radiator under warranty,after filling it back up I started the jeep and with 5 to 10 minutes it started to hit the red line. I shut it off and coolant stared leaking past the lower hose at the radiator,the strange think was the coolant was cold,the lower plastic part of the radiator...

I have a rubicon 44 built by g2,it has there gears and axle shaft .there has been no issues with the gears,I have only broke one stub shaft and it was replaced with no problems.hAve been running this front end for two years

Hopefully they are made in USA,not assembled in USA buy parts made in china

When I replaced my motor I called warn about there replacement motors they told me the motors where made in China. I ended up buying one from a company called db electrical.it too was made in China but cost less.

There all made in China