Search results for query: *

These are blue correct? Want to verify my eyes aren’t deceiving me.

14 bolt pullout from a cucv. Locker was removed and replaced with a set of spider gears. 4.56 gears. Axle is complete minus tires and wheels. It’s also missing a couple of diff cover bolts. Comes as pictured, but tires and wheels not included. Text 205 332 2782 Located in Argo, Alabama Can...

Bump $220

Left and right knuckles off a Chevy Dana 60. They are bare and come as pictured. A little rust pitting on the knuckles, otherwise in good condition. Located in argo/Trussville area. $250 obo Can ship in 2 flat rate boxes. Text or call 205 332 2782

Text sent

Which year wagoneer width? And 5x5 bolt pattern??

I’ve seen some ljs on eBay go for over 30k. Clean rubicon’s with less than 10k on them. Just have to be patient I would suppose. Auto trader let’s you search US wide and for low milage. I would search there weekly if I were you.

You’ll have better luck watching eBay or joining a more lj specific forum. Goodluck.

Selling a set of rear 14 bolt full float hubs from a 2000 srw axle. One has a dent/gouge on the mounting face, but did not leak gear oil at any point, see picture. One stud needs replacing. Comes with good bearings and bearing races still installed. $sold Located in Argo, Alabama

Selling 4 wheels and tires as rollers. Tires are no good and all mismatched. I plugged one sidewall to keep it from leaking. Used for rollers on a Jeep project. 16” steel wheels 8x6.5 bolt pattern Old worn 245/75 tires Located in Argo. $60

I got a set of 30 spline lockouts from a cucv 60. Message sent

A bolt in into what? They are all leaf sprung, there’s plenty of info out there on the waggy axles and the 2 major differences through the years. Unfortunately waggy axles are harder and harder to come by these days. Keep searching and you’ll find one, or find a 78 ford hp and cut it down to...

Found one. Thanks hardline

Still looking for a dodge steering arm. Push pull oem style, off a kingpin dodge 60.

Found one. Thanks kickdeez.

Any update?

Looking for an oem(push/pull) steering arm from a dodge Dana 60 kingpin.

You’ll have better luck running an adapter from ORD. No spud shaft. And almost half the cost.

Looking for a set of tj uppers, black diamond(textured black) if possible. I’m located in bham Alabama , so the closer the better. 205 332 2782

I’ll send you a text