Sold/Expired 465 205

blacksheep10 · Nov 10, 2009

chevy tranny and tcase. out of a 74 chevy 4x4. $300
I have about 6 205's, and several of these trannys. I'm in the SE within a week
Kelly
913 731 3040

CheapJ7 · Nov 10, 2009

what u doin in the SE???

blacksheep10 · Nov 10, 2009

CheapJ7 said:
what u doin in the SE???

visitin, you need some **** laughing1

blacksheep10 · Dec 28, 2009

orig post should say 74 chevy.
complete bellhousing to tail. also have crossmembers, mounts, flywheels, old clutches that would get you going, driveshafts, whatever.

CheapJ7 · Dec 28, 2009

blacksheep10 said:
orig post should say 74 chevy.
complete bellhousing to tail. also have crossmembers, mounts, flywheels, old clutches that would get you going, driveshafts, whatever.

I need a front shaft that will fit my 85 Chebby...

1310-10 bolt to 205
Really its just the slip that crapped out.. Its the fine spline one, not course...

GONOVRIT · Dec 29, 2009

Do you have a hydro bell for any of the 465's?

blacksheep10 · Dec 29, 2009

CheapJ7 said:
I need a front shaft that will fit my 85 Chebby...

1310-10 bolt to 205
Really its just the slip that crapped out.. Its the fine spline one, not course...

85 will be 208, and thus a long *****. If your cv is still good, did both splines trash out? If so I have a couple short fine spline units that we could cut and reweld, bring it up wed.
If not, my buddy that parts cucv trucks and has like 100 shafts laying around will have one, they are 400/208. You can lengthen and shorten at will with ease. I prob have 15 front shafts so we can have a look.

blacksheep10 · Dec 29, 2009

GONOVRIT said:
Do you have a hydro bell for any of the 465's?

onlyl one and its currently in use. I might pull it and put a 400 in the truck, nobody wants a 4 speed on the road in a mall truck. Currently not for sale, but if I pull, I'll post.