Menu
Forums
New posts
Search forums
Calendar
Monthly
Weekly
Agenda
Archive
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Help Support Hardline Crawlers :
Forums
Rock Crawling Forums
Tech & Fab
99 Tacoma window replacement ?????'s
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Fordzuki" data-source="post: 1479216" data-attributes="member: 17662"><p>Pretty easy. Just remove the trim panel, and peel back the vapor barrier. You'll have to hook the switch back up to roll the window down enough to expose the two 10mm bolts holding the glass to the regulator. Remove these and remove whatever is left of the glass. If the glass was broken, pull the rubber window run channel out and clean it VERY well. An airblower works good, but you can just turn the channel inside out and wipe the glass chunks out.. One chunk left in the channel, and you'll probably be buying another new glass when you roll it up.</p><p> Put the run channel back in, then from the outside of the door, put the front end of the glass in first, then with the glass in the run channel in front, rock the back down and into the run channel, lower the glass into the door till it lines up with the regulator and reinstall the two 10mm bolts. (these could also be large phillips screws, I can't remember exactly offhand)</p></blockquote><p></p>
[QUOTE="Fordzuki, post: 1479216, member: 17662"] Pretty easy. Just remove the trim panel, and peel back the vapor barrier. You'll have to hook the switch back up to roll the window down enough to expose the two 10mm bolts holding the glass to the regulator. Remove these and remove whatever is left of the glass. If the glass was broken, pull the rubber window run channel out and clean it VERY well. An airblower works good, but you can just turn the channel inside out and wipe the glass chunks out.. One chunk left in the channel, and you'll probably be buying another new glass when you roll it up. Put the run channel back in, then from the outside of the door, put the front end of the glass in first, then with the glass in the run channel in front, rock the back down and into the run channel, lower the glass into the door till it lines up with the regulator and reinstall the two 10mm bolts. (these could also be large phillips screws, I can't remember exactly offhand) [/QUOTE]
Insert quotes…
Verification
Post reply
Latest posts
Pluging holes
Latest: baldduck74
Wednesday at 3:56 PM
General Discussion
For Sale
Jeep TJ tube buggy for sale $32,000.00
Latest: Piros 1
Wednesday at 2:40 PM
Vehicles For Sale
2-2.5 ton Rockwell’s new in crates
Latest: Piros 1
Tuesday at 2:47 PM
Off Road 4x4 Parts For Sale
Trail gear hydro assit on a toyota
Latest: baldduck74
Monday at 12:27 PM
General Discussion
For Sale
Suzuki Samurai Cleveland TN
Latest: jeeptj99
Monday at 8:52 AM
Vehicles For Sale
Forums
Rock Crawling Forums
Tech & Fab
99 Tacoma window replacement ?????'s
Top